Servo motor
There are two technologies worth noting in servo motors. One is the high-density motor, which adopts a design concept called "large pole motor". For example, the six-pole nine-slot motor has a stator composed of nine independent poles, and a concentrated coil is wound on each pole, and then the nine poles are assembled to form a motor core with nine slots. Since each pole is independently wound and shaped, even if an automatic machine is used, the slot full rate can be kept as high as 90%. This type of motor has good manufacturing technology, and the space utilization and volume are minimized, so it is called a high-density motor. From the operating principle, this type of motor does not belong to a rotating magnetic field motor. It works under a three-phase pulsating magnetic field. Therefore, its applicability, design method and operation mode have certain particularities, so this type of motor is not suitable for square wave current drive.
The other type is an embedded magnetic steel rate servo motor, which can use the characteristics of the change of the inductance of the quadrature and direct axes caused by the salient pole effect with the position to form a truly position sensor-free rate servo electric drive system.
Sensor
In addition to various types of photoelectric encoders, magnetic encoders are worth paying attention to. The size and weight of the magnetic encoder are dozens of times smaller than those of the photoelectric encoder. It has a wider temperature range and is almost immune to shock and vibration. Its working principle is very simple. Its stator is a chip with embedded Hall magnetosensitive elements and DSP. Its size can be as small as MSOP-24 package. Its rotor is a two-pole magnet. Its resolution is 10-12 bits and its accuracy is 8-10 bits. This type of magnetic encoder is already available.
For space applications, in order to meet the environmental requirements of -35℃-80℃, it is almost impossible to use traditional photoelectric encoders. For this reason, we have developed a magnetic encoder with a resolution of 16 bits and an accuracy of 12 bits. The magnetic encoder signal processing circuit coexists in the drive control circuit (FPGA), forming an integrated sensor and drive control circuit.
The current sensor is indispensable for servo control. Low-power systems can use resistor sampling, and generally use [1] Hall current sensors. Both methods convert analog signals into digital signals and then participate in digital servo control. The output form of the above A/D conversion is usually a serial digital pulse or pulse width modulation signal.
Servo motors and sensors
Aug 15, 2024
Leave a message

