Bently Nevada 9200-01-01-10-00 Seismoprobe Velocity Transducer

The system is a two-wire system consisting of a sensor and an adapter cable. The Seismoprobe series velocity sensors are a two-wire design using moving coil technology and provide a voltage output proportional to the sensor vibration velocity.
 

Application scenarios:

• Rotating machinery monitoring: bearing vibration detection of steam turbines, gas turbines, compressors, pumps, motors, etc.
• Structural health monitoring (SHM): low-frequency vibration measurement of bridges, buildings, pipelines, etc.
• Fault identification: identification of mechanical faults such as imbalance, misalignment, bearing wear, etc.

✅No external power supply required:
Directly outputs voltage signals without additional power supply, convenient for portable measurement or long-term monitoring.

✅Anti-mechanical shock:
Not sensitive to impulse excitation, suitable for environments with mechanical shock (such as compressors, steam turbines, etc.).

✅Two-wire system:
Simple wiring, only signal line + ground line is required to work.

✅Wide frequency response:
Suitable for medium and low frequency vibration monitoring (typical range: 10 Hz ~ 1 kHz), suitable for conventional vibration analysis of rotating machinery.